Pappy

Right off the bat the primer bulb does not stay hard while the engine is running. The bulb is on the suction side of the fuel pump so...

martin mcclimon Lives in terra ceia florida. That should narrow it.

Put a Thread sealant paste on the threads for reassembly. Loctite makes a good one for example. Great stuff for any thread below the...

Easy way to see if the thermostat is working is to lay your hand on the top of the cylinder head at idle. You should be able to hold...

Way to go, Mbullen !

Low-Line was founded in 1971. If your rig is absent the 12-digit HIN plate on the stern which began in 1972, I suspect it's a 1971...

Post more pics of this. Would like to see the mfr name plate for one. Does is say where it was manufactured?

Go in to the Fiberglassics site and see what you can dig up on it. They have a very extensive library on both Glass and aluminum boat...

You may have flooded it. To check and clear a flooded situation you can advance the throttle and hit the starter without using the...

Usually any "portable" outboard has a fitting on it. Did you buy pre-owned?

Come on over to Tavares around March 20th for the big Sunnyland antique boat show. Biggest in the nation now. There are a lot of us...

As has been mentioned you may need larger cable if running that far. Remember measuring the complete circuit? For simplicity sake lets...

Checked out your work. Wow is about the best word to describe it. Well done on your part. I see you are in Florida?

There you go! In 1956 there was a one year only 30hp! Both the Johnson and Evinrude examples are really cool looking!

Factory cables are probably around 6ga or so. If making your own it never hurts to go to a larger ga. as it carries the electrical load...