Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
If you are having any issues uploading or linking photos to your posts, send them to me and I will upload them and send you back the links to add to...
Last post
I changed the photo location. I will upload them to the TinBoats dedicated server. They will not be sitting on just any 3rd party hosting solution....
This is the running list of the current Sponsors. Help support TinBoats.net by supporting these guys first if you are shopping for similar products....
UPDATED February 2018 - Help yourself! :LOL2: No need to PM me, just go to this link below and get what manual(s) you need....
Last post
Just a quick reminder to help yourselves to a motor manual if you need one. If you have one that is not on the list and you want to share it, let me...
Hopefully this guide will help you calculate the maximum amount of H.P. your boat can be insured for.
- This is to only be used as a guide.
- You can...
Last post
Using my 2017 Lowe 1040 the calculations come out as shown if I measure the transom width as in the graphic below. The calculations either come out...
I have a pontoon barge that I need to move from time to time and I am getting sick of borrowing a motor to do that. I called a fellow river rat that...
Hey guys. Found a 70hp evenrude from 1987. Commission check says 115-105-115. It does run. Should I be concerned?
Last post
I'd pull the head an investigate.. might just be a head gasket.. if the cylinder looks good, I'd put a new head gasket and run it.. but before doing...
Hi Guys
Looking for some advice. I have a 2007 Lowe AN140s 14 foot Lowe Fishing model aluminum boat with a 207 25hp mercury EFI 4 stroke on the back...
Last post
A tachometer is not simply a tool to have when adjusting the prop.
A tachometer is absolutely paramount! You simply can NOT tune the prop and motor...
Just pick it up yesterday. There is rubber rod/tube that is loose on the leg and I not...
Last post
I have this same motor, so the loose rubber rod is used to lock the motor for reverse. It's supposed to sit inside that little notch, kind of a pain...
It's been too long since somebody posted some classic motor eye candy. I found an old Corsair husk on craigs for $50. Was missing cowling shells and...
Last post
An appropriate holiday to remember everything that those people did. Not just the ones that died, but also those that lived. They came home and built...
While hooked up to the muffs, I have water pouring out of the top cylinder at the spark plug.
I wish I could uplaod the video to show how bad it is,...
Last post
You may want to go over it with some very fine grit sandpaper (like 800 grit) on a flat block and see if that polishes it up any without removing any...
I didn't get my boat out much last year and even think I still have some gas in it from the year before. I am guessing there is about 8 or so gallons...
Last post
Well, you talked me out of it. I finally was able to get most of the fuel out of the tank by unhooking the hose to the motor and squeezing the...
I have a 2006 25 hp 2 stroke 2 cylinder manual start outboard Yamaha #25MSH I got the motor from my sisters house and have no idea how long it’s been...
Last post
I did some more inspecting on the motor and pulled some things apart the flywheel key is sheared and broken in half I got some new ones coming but I...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
