Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
This is the running list of the current Sponsors. Help support TinBoats.net by supporting these guys first if you are shopping for similar products....
I have done some research and still dont fully understand marine batteries..the bci group size o ly refers to the physical size of the battery, yes?...
Last post
Group sizing in batteries only describes the physical size of the batteries. It doesn't have anything to do with capacity. However, larger batteries...
I'm in need of an anchor light for a small 1440 jon boat I'm working on. My 1648 has one of the nice flexible 48 led ones that THMarine sells and my...
Last post
I rescued the old Atwood nav lights on my tin with LED bulbs from West Marine.
Then the base for the all around light broke, almost $40.00 there but...
In a previous post, I was troubleshooting an issue re-starting my motor once on the water. Went through and re gapped plugs. Put some seafoam in gas...
Last post
Few things ... otherwise to me it sounds like you got a bad battery.
CHARGING - I look for 12.7 VDC or use the electrolyte test when assessing...
I have a bass tracker pro V 17 that I have installed a 2018 three cylinder Suzuki in place of the two cylinder Johnson. There’s a selector switch on...
I have a Garmin fishfinder which doesn't have built-in auto off. Twice, I had forgotten to turn it off & then 2 weeks later when I get to boat ramp,...
Last post
I need to wire one of these into my pontoon radio. My wife constantly leaves the radio on and it's drained down the battery before. I go to put it...
I have a 14ft Polarcraft and just ordered a Lowrance Elite9ti2 with a 3 in 1 transducer.
I was wondering if people have problems with the sidescan...
Last post
Its a pretty big band on the left side... I havent gone by structure on each side to compare them. Life is very busy right now and I havent had time...
Can anyone tell me how i would install a remote bow switch , can it be wired in from the 3 wires located in the throttle handle or would you have to...
Last post
Are you looking to have a trim switch at the motor, a trim switch at the controls and a trim switch at the bow? The wiring should be there for the...
Alumacraft 1860. Bought used. Here is what I discovered.
BOTH sockets for nav lights were corroded. Replaced both. (still dont work) Brker not...
Last post
Problems solved. I got lucky with a bad breaker & a disconnected wire. Plugged it in, swapped breakers and all came on ! Yeaaaa.. I have ordered all...
Good afternoon everyone,
Hope everyone is doing well and safe. I'm in the middle of wiring a few projects thought I'd try to knock it all out at...
Last post
See if you can use this info too, a simple small boat circuit and a neat breaker buss with both +Pos and -Neg connection points. Note the stern light...
I want to upgrade my Edge 12 volt to a 24 volt motor. I have a G3 with stick steering and the 12 volt motor does poorly in current. I already tried a...
Last post
There is a model of trolling motor that can automatically deploy and stow. Minn Kota makes it, it's the Ulterra model. That think can automatically...
Hi folks,
New to boating here. I have a small trolling motor and two batteries. Can you give recommendations for a good charger?
Also, since I live...
Last post
I just recently picked up the ProMariner 3 bank charger from Amazon and installed it. Been working great so far. Nice not having to deal with moving...
I would like to put a nicer fish finder on my boat, and on my wish list. If COVID continues to be something that reduces or eliminates other...
Last post
I don’t have a problem with them . They are simple to operate. . With that said I do use a remote for both units. I use the sh$t out of both to keep...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum