Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
This is the running list of the current Sponsors. Help support TinBoats.net by supporting these guys first if you are shopping for similar products....
I just bought this boat for $140. It came with a boat and trailer and a 1958 Johnson seahorse 30 horsepower. The motors in really good shape just...
Last post
Ther is a tag on the inside transom but it's so far gone that I cannot make out any information on it. It looks like it's a metallic decal more than...
Hello all - I have a 2010 G3 with a 50 hp Yamaha 2 stroke set up with stick steering. I've had it a few months and have already damaged 2 props while...
Last post
Yes jet foot outboards are sensitive to height and setup.
Also the shift cable is a little different, I can't say if your original cable will work...
Just got my first jet boat its a 18ft alumacraft with a 115 mercury. Took it out for a short run for the first time today and i loved it. I know...
Last post
Look for the most undisturbed water flow. That can be a vee or slick, deeper water. To go down, I turn the bow upstream and use the trolling motor to...
I have a 16'x56 flat bottom welded jon (Weldbilt) with a Yamaha 60/40 tiller. Purchased new in 2014. You guys were really helpful when I was looking...
Last post
I took all of the weight off of the knee brace on my boat. I added a piece of rectangular tube behind the rear bench seat and used two pieces of 3/8...
I need to figure out the manufacturer and an approximate year to register this boat.
Kinda looks like a Lone Star, except seat mounting.
Please...
Last post
Well, the transom brace doesn't match mine. Mine is a cast aluminum, rather than stamped one. My boat is a 10-foot, (but actual distance is closer to...
Hey everyone its been awhile. I just picked up a 2004 mercury 90/65 2 stroke, to replace my 2007 mercury 60hp 4stroke prop. I have a cnc manual power...
Last post
My 1648 weldbilt has a canted transom, so there may be 5% or so tilt. Put on a 50/35 short shaft tiller and it needed to be lifted up to the last two...
My awesome welding nephew just put together a frame and added an aluminum front deck (removable) and also put in some solid aluminum for my bow mount...
Last post
Update: Took the boat on the lake this past weekend. The weight of the deck and bow motor was fine. The 1542 was solid and stable.
Another awesome day on the river....until the end.
At 2:51 on the left side is the rock going up river.
10:40 is right before I hit.
Last post
I really was impressed that the holes were not more severe. After repairing my boat I took a picture of the rock with the water lower. I TOOK a chip...
I have been looking at purchasing a Lowe Pathfinder 1760 with a 115/80 mercury. Does any one know how they run? speed? Holeshot? I’ve only been in a...
Last post
Thank you Riverdog! Awesome little sheet and a lot of good information on it. So I could expect somewhere in the 30-35 ran up and down river most...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
