bassnbrian
Active member
- Joined
- Jun 16, 2009
- Messages
- 44
- Reaction score
- 0
Hey
CRAPPIE_SLAYER said:Nice job on the paint. What kind of paint did you use?
CRAPPIE_SLAYER said:Pretty new at all of this, but from the way I understand it, if you go by the plan you made one the first page I would think that the combination of the support along the floor and the storage area down the one side of the boat would eliminate any flexing. Again, I'm no pro, just my .02
If you take the rod holders off and use a piece of 1x1x1/4 angle aluminium and run it from the point the top of the rod holders connect to the side and fasten it to the floor where the seat is connecting. You will retain your side support. Then you will mount your rod holders too the new aluminium angle
bassnbrian said:If you take the rod holders off and use a piece of 1x1x1/4 angle aluminium and run it from the point the top of the rod holders connect to the side and fasten it to the floor where the seat is connecting. You will retain your side support. Then you will mount your rod holders too the new aluminium angle
Thats a great Idea. plus the additional length of the bar with the rod holders (if im understanding you correctly) will give room for more rods to be held. (there is nothing that bugs me more than a bunch of rods all over the place while im trying to fish lol...and I bring ALOT of rods)
When doing this though...do the bars need to be at a certain angle? As in will they need to be at a 45...and thus be in the middle of the floor space? (and tripped over) or can they be at a sharper angle where they connect with the floor support and still offer enough support?
Thanks a bunch!
Enter your email address to join: