200racing
Well-known member
it time for my project and build thread; as deer season is over and my first tourn. is 2/18.(cutting it close)
to start thanks jim for the site and everyone who has shared their knowledge. =D> hope to put it to good use.
be forewarned i am not great at turning my thoughts into words.i butcher and leave stuff out all over the place.
check list.
[strike]tear out old carpet[/strike]
[strike]remove old glue residue[/strike]
[strike]fix drainage[/strike]
[strike]remove dead 350gph livewell pump[/strike]
[strike]remove 1 of the 4 gallon livewells[/strike]
[strike]remove heavy floor[/strike]
new carpet on decks
[strike]seal the deck wood[/strike][strike]extend rod holder[/strike]
[strike]add rod storage[/strike][strike]install new 500gph livewell pump[/strike]
[strike]install 15 gallon livewell[/strike]install rod holders for fishing
[strike]paint vertical surfaces[/strike]install bluewater leds
[strike]wire in bank lights[/strike][strike]install new aluminum floors[/strike]add pedestal seats
[strike]add 3 hatches[/strike]
i bought this boat last fall knowing i was going to cut into it. being a panfisher model it had almost no rear deck. it had two 4 gallon livewells that barely held 5, 12'' bass. it also had two 1 gallon minnow wells. the carpet and interior tells a story of being left outside alot.
how i got her
to start thanks jim for the site and everyone who has shared their knowledge. =D> hope to put it to good use.
be forewarned i am not great at turning my thoughts into words.i butcher and leave stuff out all over the place.
check list.
[strike]tear out old carpet[/strike]
[strike]remove old glue residue[/strike]
[strike]fix drainage[/strike]
[strike]remove dead 350gph livewell pump[/strike]
[strike]remove 1 of the 4 gallon livewells[/strike]
[strike]remove heavy floor[/strike]
new carpet on decks
[strike]seal the deck wood[/strike][strike]extend rod holder[/strike]
[strike]add rod storage[/strike][strike]install new 500gph livewell pump[/strike]
[strike]install 15 gallon livewell[/strike]install rod holders for fishing
[strike]paint vertical surfaces[/strike]install bluewater leds
[strike]wire in bank lights[/strike][strike]install new aluminum floors[/strike]add pedestal seats
[strike]add 3 hatches[/strike]
i bought this boat last fall knowing i was going to cut into it. being a panfisher model it had almost no rear deck. it had two 4 gallon livewells that barely held 5, 12'' bass. it also had two 1 gallon minnow wells. the carpet and interior tells a story of being left outside alot.
how i got her