Still Afloat

Apparently it is not acceptable to love your country on this forum. I cannot fund a forum that practices censorship and I’m canceling...

Perhaps as a last resort. I’m not even sure if it has screen since there is no access to see the pick-up.

Good point on the carbs. I understand that fuel starvation is a very bad thing and that’s why I’ve minimized running the engine. It...

That makes sense. Parts are a little scarce for the motor and I’m being cautious about digging too deep. May have to check the reeds...

The tank was cleaned out down to the last ounce or two through the fuel gauge port. I have not replaced the fuel line between the fuel...

Yes, I forgot to mention that. The voltage reg is only two years old and it’s regulating properly but, I will test it under load. I...

So the 97’ Evinrude 115 2 stroke on my Crestliner has been giving me fits. It starts missing real bad at about 1/4 to 1/3 throttle...

Both good ideas. If you like Goof Off try this stuff. I think it works better than Goof Off for labels and other gummy stuff. Some...

Another fellow expanded or replaced the bow plate on his boat earlier this year for the same reason. There’s a thread somewhere on the...

Thanks, guys. Will try the pressure washer and pot scrubber method. It certainly could have been a lot worse. The tire outfit will...

In case anyone is wondering, that was mostly catch and release. Nineteen trout went back in the lake and two for the table.

Caught 21 trout today. It was a bit chilly with a high of 40, drizzle and a 10 knot breeze. The action kept me warm for the most part...

That is probably the route that I’ll take. I’m considered Total Boats, Total Tread or similar. Just need to convince a buddy with a...

The guy that I talked to said black or dark grey for the urethane stuff. I’m having a hard time parting with over $800 for a simple...