Pappy

Good feeling isn't it!

I probably see more antique and vintage outboards running in a years time than a lot of you will see in ten years. The majority of smoke...

If you do decide to start the engine make sure you have the gearcase submerged far enough to cover the water pump entirely prior to...

No, they are not even close but......with a little fabrication anything is possible. Wondering why though?

Okay....marineengine.com is your friend. Look at the model number of your engine and go there. Look up the correct parts breakdown and...

A magneto creates its own current to run an engine. Same as a lot of very simple aircraft engines or most older outboards. Good systems.

Has been done a million times. There are tons of donor motors out there as well for the correct parts. If the flywheel has engagement...

Have to admit I should have caught the issue with the muffs sooner as should at least 2 or 3 others in here. Surprised we did not. The...

Grab the part number and see if anyone on Ebay has the part or find one off of a parts or donor motor. These almost never fail. Have you...

Would be good to know the exact model year of this engine as there were some late 70's engines that had a plastic tube near the top of...

It is really not a best guess. Keep in mind we are talking 2 strokes here. Although it may not make sense (V6 vs 2 cyl) the smaller twin...

Go larger. Believe it or not the two cylinder 28 would most likely pull more initial amps than a V6 will. I would do nothing less than 6...

Lets start at the beginning. The only comment that caught my eye so far is the partial swamping. Exactly how high did the water get in...

Believe that was a pushbutton or electric shift. Look at the control box and count the number of control cables (not the harness) and if...

Any single line OMC fuel line fitting will work. There is no difference. They are all the same. Always buy quality!!! The single line...