airshot's latest activity

As mentioned above, I would lift the panel in that area and install a square of 3/4" plywood from rib to rib, glued and or screwed to...

More than 8 years back I found an old Jon boat laying in a field that was in poor condition to say the least. It had been dragged over...

Until they have a problem ! Service after the sale when a problem arises is what makes a purchase a good one or a bad one !

I’d make a removable roller for the back of the trailer.Full width pipe with a bigger piece of PVC around it. It would make loading a...

Yes....by all means check with mfgr ! Some can be set on any side but others cannot....best to be safe, especially when it comes to...

It will work if you can get the proper tongue weight on the trailer and it sets low enough to launch the boat. You can always add some...

I agree with this. It really doesn't take much at all. In the example I posted above (14' Alumacraft, 9.8 Merc 2 stroke), just moving...

It should work well for your planned uses.

The 25 hp motor will work for sure. You won't be disappointed.

Acceleration is the big difference, but in a boat the faster rpm gain of the two stroke pushes it ahead. Don't get me wrong, the new 4...

If the two S motors are in excellent condition, I would go that route. Easy to work on and maintain and faster than a four S motor. No...

What area will you be boating and fishing ?

Welcome, Loosescrew! Do you have a boat yet, or a project in line?