alval

I am currently working on an 85 Lund. My rivets all look good but I am going to coat the entire floor with Flex Seal before I replace...

Well, took everyone's advice and stripped all the foam out as well as the questionable wiring. Next up, unless someone can give me a...

I am sure I am a bit late with my answer but better late than never / when I did my boat, I found the pours in each dept. of the boat...

I agree def. take your time doing it & you will also find that you and your boat become one esp. if a newbie like I was. Havin a boat is...

Here is a link to a restore I did on an 81 Pike. https://www.tinboats.net/threads/the-life-of-a-1981-lund-pike-dlx-16.43801/ Have...

https://www.tinboats.net/threads/the-life-of-a-1981-lund-pike-dlx-16.43801/ Try this

I did a Lund simular to yours and documented it on this site. My boat was a couple years older. the aluminum plates under the floor...

You're going to be waiting a long time for that foam to dry out. A very long time. You'll be better off removing the foam replacing it...

only diff w/ me I didn't have foam in belly of hull only along sides and bow, but still replaced whole deck