I was Pretty lucky with that. I've probably only spent $20 so far and that was on some fittings.
I made the livewell at work with some stainless we had that we couldn't use because it was scratched on 1 side. The stainless would have been around $60 for the piece I used. So with tank, pump...
Ya, I actually got the idea of removing the middle seat from you. You got yourself a nice boat there.
As for paint, I've got to wait for it to warm up abit.
Thanks. Its alittle shallower than I'd like but i'm happy with it. Ya, that is the overflow and it is abit higher,. I cut the wrong size hole for the overflow so what I'm going to do is run a 90 angle up on a 45 to raise the aerator line. Should work.
Did some work tonight. I started with the plumbing for the livewell. I'm unsure if I should use a pump I got for free because its 24v and all of the wiring in my boat is 12v so I stop there and started carpeting the boat.
I got most of the carpet done but then I ran out of carpet. I'll have to...
Its a 1432. There was ribs on both sides of the seat so I don't see it being a problem. Its still my first mod so I'm pretty new at this. Guess I'll have to wait till the spring to see.
Finally I got sometime to get some work down on the boat this week so I tackle the livewell.
I cut out the hole in the back seat where I'm going to put the livewell.
I had some spare time at work so I decided to make up my livewell. I made it out of stainless steel.
Here is a pic after I...
Hey guys,
Thia is my first boat ever. My buddy has a 10" jon boat that we use and thats what got me hooked. So last august I decided to buy one. I found a 14" jon boat for $300 so I bought it up. Bought a rusty old trailer for $100, took the grinder to it and it looks as good as new. Got a 9.5...