Recent content by cromagman

I have not tried that yet as I have'nt had the motor on. What I have done is check for continuity between the negative battery post and the hull, and there was none. The same results betwwen the negative bus terminal and the hull. Once I get the motor on I will check it your way. Thank you.

That makes sense. Thanks for the quick response. I just painted the boat today, so the last thing I neede was to rewire.

I installed a permanent Moeller fuel tank in my aluminum boat. After thinking that I had all the wiring done I looked a little closer at the wiring instructions and they stated that I should run a wire from the sender to earth common. I do have one wire running from the sender to the fuel gauge...

Thanks for your help, I was hoping either way would work. Warranty is not an issue, 87 Yamaha on a 63 Alumacraft

I don't know if it makes a difference or not,but I want to add a fuel/water separator and I I don' t know if it goes online before or after the primer bulb. So if someone out there could clear this up I would really appreciate it. I have a fifty horse outboard.

IN

I have a 1987 50elh Yamaha which is a 50hp 2 stroke. I have only had it running once before I put it up for the winter, and it seemed to run fine. I did notice later that every ground wire on the engine had the insulation cooked off. I sure it has been like that for quite a while. I...

I guess I can only post one photo at a time, so, here's a better one

Here's my 1961left Alumacraft Queen 16. I've never had it in the water, so I hope it floats! These are the "before"pictures. In a few months I will hopefully have some "after" pictures.

Its pretty simple, trim the pad to fit the sander. When it loses its effectiveness turn it over and use the other side. I have a sub standard repair on my left shoulder, and a fused right wrist, and this is a heck of alot easier and has better results than doing it by hand!

I will try to send some pictures. Here goes!

I've tried to post pictures, I wish I could cause I'm quite proud of the old gal but haven't had any luck. I'm not on a computer, its down, I'm on my phone. Maybe I'll have more luck when I get the computer working. Sorry

A little intro. I recently bought a 1961 Alumacraft Queen 16. And I wanted to get some info on it so I tested Alumacraft customer with the HIM. And within two days they got back to me with everything I wanted to know about this boat. They even sent me a picture from a sales brochure of the...