Recent content by florida strain

14ft. Monarck, 25 Mercury.

my favorite is a f-13 rapala , however big huskys been working good lately last few trips ,till they start feeding up closer in the water colum.

wow i have the same boat 14 monark, now known as sea ark , how much steel flex did it take to do the bottom, also what kind did you get ,the slick stuff for airboats? thanks cant wait to see more from build.

thanks guys , i always wondered about that, the ncs looks good so far man.

nice rig i was looking at those ncs modles, is ther enough room to put 2 batteries and a 3 gallon tank in the back transom part? without overload?

well after 2 weeks in the shop 600$ later from the local marina, in for a carb kit and water pump impeller. they built it back wrong and now i have no reverse, also it has to be in reverse for it to start, instead of nuturel, is there a way i can fix this? this marina really blows, when i went...

i have the same motor. and the same psi, 120 which is good. i have the vengance prop by merc. installed by the previous owner.

can someone sit up front good and stable on the deck , with the gas motor underway? thanks.

turned out nice . love the battery compartment

X2 ,The most you can afford ,you can always run it on low or just bump the throttle.

Looks sweet so far. Is there room (or an opening)to run wires through the original side boxes(transom support) between the back bench and transom on alumacraft models? Or would you have to drill out a hole to run electrical wires from back to front on a factory hull. Thanks.

Thanks, I was looking at the 14 ft. trailers for a 14 ft. boat. The full boat would be on the trailer w/ a 15 hp hanging off the back,lifted up .The trailers Ive been looking at seems to be mostly angle iron. I was going to mount the winch on the front rail and use the side rails as kind of a...

Can I use a utility trailer to haul, launch, and load a flat jon by removing the rear gate and adding a winch? I would like a trailer for boat and for hauling equipment.