Recent content by Siguz

Attached is a photo of the ngk box. The universal wires that I used are too long but they're doing the job. My motor spends most of its hours at WOT. I rarely troll and primary anchor when I get to where I want to go.

I've got my fuel tank up front too and also had concerns with the 15 feet of hose. I've no issues at all. My motor is an 89 and it seems to run best with NGK surface gap plugs (can't remember # but I can get it for you). I've experienced the same hesitation as you described. Turned out to be a...

Awesome. My wife wants me to make cup holders.... Solution found. Thank you

https://forum.tinboats.net/viewtopic.php?t=34515

Bevel is a must. But a pain in the *** lol. Take a look at my build. Link should be in my signature. Using the same angle that held the bench, L brackets, and some steel bracing, my front deck is SOLID.

Look below the left rear grab handle. You might find the serial number there. I was only able to find mine in that location while I was painting it.

I know lots of us experience the issues of coughing stalling and power loss. Usually we chalk it up to dirty carb or bad gas..... Last night I discovered it was my plug wire on cylinder 1 It looked fine until I pulled it off in 2 pieces. Looks like it just cooked itself! Anyway, running...

https://www.veradoclub.com/index.php?topic=137.0 In not sure where I found this link but it gives a great over view of desired motor height/positioning.

HEY Check out these 2 threads. Lots of us have done this conversion to our OMC motors. I now have the big carb on my cut manifold and I love it! Hope some of this info is helpful https://forum.tinboats.net/viewtopic.php?f=4&t=31894 https://forum.tinboats.net/viewtopic.php?f=4&t=23898

I agree. Looks like it need to go up.

43 with the 10x13. I think it can probably handle 10x14 but that depends on each application.

got the Carb on. 41km/h with a 10x12 prop. Gonna try a 10x13 and see what happens Motor seems to run better now that there are no restrictions.

got the Carb on. 41km/h with a 10x12 prop. Gonna try a 10x13 and see what happens Motor seems to run better now that there are no restrictions.

Installed larger carb today. Had to cut manifold a little further to accommodate. I guess I didn't cut it out fully last year. Hopefully I'll be able to get on the water before the end of the month. Water levels are rising and ice is melting.... Not fast enough though.

Well isn't that fancy! I was hoping you were going to say aftermarket [CONFOUNDED FACE]