Okay
Now one of my problems a floor installed in the boat will not allow me to see the exact layer of aluminum
Will measure thickness of keel aluminum and the rivet that is there assume 3 layers and the other 2 layers.
What head type did you use?
Thnx
Hello
Have some rivets that i need to replace on my MirroCraft 14ft V hull
There is a floor in it so I want to use blind rivets.
reading it would appear I should use 1/4" diameter.
The rivets will be passing through 2 layers and 3 layers of aluminum.
Can someone give me the part number form...
Thnx for the pics
Think I will convert my trailer to bunks but keep the keel rollers also. Was reading the you should set boat up to share the load on the bunks and keel rollers.
Any thoughts on this plan
What did you makethe guides out of
If I was to keep the rollers any help on adjusting them?
This current configuration is it okay to use? I am have some problems with it that is why I am asking.
Will look around for some bunk hardware
Your sig picture appears to have the same trailer type but it is hard to see for sure
When I got the boat the rollers were barely touching. I have some long trips and want to make sure they are setup right.
Okay added some pics. Would really apprecate some help here. Currently I...
Hello
Have a 14' miro craft on a trailer with rollers
It has 4 keel rollers
2 rollers on each side at the rear of the trailer near transome
then it has 2 more rollers that are located forward of that to the side of the keel
The rollers are adjustable up and down and can have the angle changed