Stand Up's latest activity

I am getting ready to give all of this another try. The copper water pipe has a rubber grommet on it at the impeller housing. I just...

A good number of years ago, had a 1977 35HP Johnson. It died prematurely, due to an earlier life in salt water. My memory from working...

I do not have a manual for this motor. I purchased the boat and motor less than a month ago and wanted to fire it up to see if the motor...

Not to be a jerk, but do you have a factory shop manual for the motor? Get a shop manual and it should answer all your questions...

I boiled the thermostat pictured above and it works correctly despite looking terrible. The tell tale and the rubber hose attached to it...

PUMP - WATER TUBE - THERMOSTAT - ENGINE BLOCK-- TELL TALE 1/2 split the problem If you start it briefly with the thermostat OUT...

Could be a blockage somewhere in a water passage...Could try running weed eater line up through the tell tale as far as you can get it...

I will give it a try in the morning. I didn't even realize these motors had a thermostat until this morning. And the little piece I...

how about trying to start it with the thermostat AND the cover OFF.. see if you get sprayed in the face...

I am running it on muffs the rectangular type and I have the hard plastic muffs and the rubber type that fit much tighter.

Impeller has a elliptical key in it and I can feel it spinning inside of the housing when I rotate the shaft by hand. I think the motor...