TinBoats.net
The original aluminum boat site!
Transome outboard plate material
- Thread starter vadney83
- Start date
Help Support TinBoats.net:
Welcome aboard sir.
If the material has a waffle design on the exterior, it would work fine. I think smooth material would allow slipping, but if you through bolt the OB it would obviously stay put in my opinion.
If the material has a waffle design on the exterior, it would work fine. I think smooth material would allow slipping, but if you through bolt the OB it would obviously stay put in my opinion.
- Joined
- Feb 18, 2009
- Messages
- 2,415
- Reaction score
- 2,286
- Location
- Perrysburg Ohio
- LOCATION
- Perrysburg Ohio
Wood was primarily used because it was cheap, but back in the day many motors used clamps rather than bolted thru. If your using a clamp type motor the wood gives the clamps something to bite into, where the synthetic material would be somewhat slippery. If your bolting the engine on, then it won't make much difference as long as the transom is solid.
