Search results

Guess I’m making a few mistakes tonight, sorry!

Enjoy the extra photos:)

Just did mine, just outer topside. Random orbit and hand sand, rattle can self etching primer, Petit ezepoxy sea foam green, roll and tip. Two coats

Thanks to all who helped on my transom height post and Repower post. I can’t diagnose this motor and don’t have local resources to help. Can’t help but wonder what it needs, feels so close:)…..

Sorry for terse post, I keep losing my replies before I can post! 1974 25hp evinrude, ran great then didn’t. Fresh gear oil, plugs , gas, carb clean, thermostat, fuel pump. Will only throttle up half speed. Upper plug fouled more than lower. Came with boat,I’m moving on from this motor

Can only get motor to throttle up to about half power. Upper plug is fouled more than lower. Both are month old.

New 25’s are going to be 150 lbs plus I think, going to look at 20’s. They should be around 110-115. Interesting to know about the power being at the prop. Thanks for the help

Need to repower my70’s 14’ side console duranautic, It has evinrude 1974 25 hp. Are the new 25 hp motors too heavy and should I look at the 20 hp motors that weigh similar to the old 2 stroke? Thanks

The boat is 20” transom. I was way wrong. Spent time Saturday looking it over and getting used to it. I was confused by the controls, thought I had bad throttle cable, realized it just doesn’t have that much travel. It needed a prop shaft drive pin. 1972 boat , ‘74 evinrude 25, replace gear oil...

Thanks everyone,i will be able to spend time today checking everything out a little better. I’ll post more later.

You can see how the transom is straight across

Hi, i have a 1972 duranautic 14, side console. It has a 1974 Evinrude 25 electric start. This is new to me. The boat is in great shapeand I hoped to put a 20 hp yamaha on it, as it turns out the transom is 25”( ?), i can now see the evinrude has a 5 “ extension kit on the shaft. So, can I cut...