Search results

I don't have a welder that can do it but there are guys in my area next concern is how would I know they are doing it right like any special prep

ok I pulled the floors out of my boat. and I found this odd screw just stuck thru my hull.it is sillyconed on outside and just hanging in the open on inside. there is also a bend in that area . I had thought about smashing a rivet in there but think it might be a issue due to the bends the...

well it's looking like ford blue on the bottom and white on top . now I'm also thinking of painting the inside too I'm also still trying to decide on casting decks not to sure about hw to go about bracing the decks. I had thought about having 2 rails riveted in along the sides to work from but...

well it looks like the gluvit will seal the leakage I had I used a qart of it and only went up to the rib down the side of the boat. Thought is if i'm getting water in above that she is going under anyway . i just need to top coat it but I'm not sure on the paint colour or type to use I may...

ok so yesterday was beat the rivets and today was gluvit day. now I need to figure out what to use for paint on the boat type and colour then I will flip it over and will start on the inside I have all the seats removed so pretty open to options paint pointers welcome

I have been reading a fair bit on here and looking that is how I have gone from a front to a mid deck. My thought to removing the middle seat was for more area under the deck for storage/options I figured i would leave the rear seat in for me to sit and drive then deck the mid and leave the...

ok got this 14 ft harber craft and need to do a few thinings it has some leaks and need to pound rivets then going to gluvit the bottom. i been thinking about decking the boat but having a hard time deciding what to do. At first I was going to put a deck in the front and put the fuel and battery...

Ok like it says I'm new and have a 14 ft Harber craft in my driveway waiting for me to make changes. things I would like: new paint inside and out casting deck in front comparments for livewell,battery,gas tank some nice seats think that is a start I will have lots of questions as i go like...