Search results

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. Tin Man

    Trolling Motor Selection - Volts, Thrust, and Shaft length

    Preparing to purchase a new TM. Going with Minn Kota Terrova (no transducer...only remote and iPilot) Spoke to MK today. Here are MK answers to my questions about thrust, volts, and shaft length.... Thrust - MK: 2# for every 100# of boat weight (including motor, gear, passengers, etc). My...
  2. Tin Man

    Electronics/Graphs and TM info for Dummies!

    Are you referring to the thread on transducer mounting? If so, that is a completely different thread/question.
  3. Tin Man

    Electronics/Graphs and TM info for Dummies!

    Electronics and TM... Need to some guidance and information. I am a total novice on latest TM and graphs, Looking to upgrade my stock 12V/42# TM and FF/GPS. Upgrade to: 24V/80#/60" with iPilot/GPS and Lithium Batts. Lithium Batts.....Two 12Vs or one 24V? FF/GPS: Purchased a new Lowrance...
  4. Tin Man

    Electronics, Fishing, and Trolling Motors

    Looking to upgrade my stock 12V/42# TM and FF/GPS. Upgrade: 24V/80#/60" with Lithium Batts. Lithium Batts.....Two 12Vs or one 24V? Lithium Specific charger? FF/GPS: Purchased a new Lowrance Live 9. Was planning to install at console. Would like a graph at bow. Perhaps I should have thought...
  5. Tin Man

    Manufacturers using treated wood in tin boats

    Tracker has eliminated all wood (except for decks) in Deep V, Mod Deep V, and Jon boat models... and are ALL welded. Not sure when this started. I consider Tracker a well designed and well built boat...especially for the price....that's why I purchased a new one...
  6. Tin Man

    Bad Start for 2nd Fall Outing

    I just noticed...that G3 is new too! Did you add the external filter or did it come pre rigged with it?
  7. Tin Man

    Bad Start for 2nd Fall Outing

    For a minute there, after reading title, I thought maybe it was your new toon! Good thing you had the external fuel filter/water separator. Boat issues, especially engine and leaks, are the worst IMO! All things can be repaired. Glad you repaired quickly and all is well. I have thought of...
  8. Tin Man

    NOCO Battery Jump Starter - Any Good?

    Your 50hp is probably carbureted...I believe Honda 50s were carbed to just a few years ago
  9. Tin Man

    NOCO Battery Jump Starter - Any Good?

    I agree on the second house battery. However, my rear starting battery compartment on has enough space for one battery or I would have added a second house battery.
  10. Tin Man

    NOCO Battery Jump Starter - Any Good?

    I'm debating between the NOCO 50 and 75. 50 is 1500 amps and is 4"x9"x5" 75 is 2000 amps and is 7"x4"x12" The 75 foot print is much larger. Space on a small boat is a premium.
  11. Tin Man

    NOCO Battery Jump Starter - Any Good?

    My new 2023 Mercury 60hp 4 Stroke EFI does have the emergency pull start rope under the cowling. However, below is what is written in manual. "Emergency Starting If the starter system fails, use the spare starter rope (provided) and follow procedure. NOTE: EFI models ‐ The engine must have a...
  12. Tin Man

    NOCO Battery Jump Starter - Any Good?

    Which model / size (amps) did you go with?
  13. Tin Man

    I messed up. SIX TIMES! Night fishing

    Boating / fishing at night can be challenging, as others have described. I've sailed (many different sailboats 20'-30' in length) at night on the ocean. I frequently sailed from San Pedro, CA to Catalina Island (SoCal) at night, but obviously the ocean is much larger than a lake and...
  14. Tin Man

    NOCO Battery Jump Starter - Any Good?

    Since I have a single starting battery that also runs lights, bilge pump, livewell, 12V receptacle, and FF/Chartplotter. I was considering keeping a jump starter on board in case the battery is dead out on water. TM could get me back but it's battery could be nearly dead when I need it. NOCO's...
  15. Tin Man

    Transom Tie Downs

    I'm using BoatBuckles and have been very satisfied with their ease of use and performance. I purchased a set of polyester protectors so metal makes no contact with hull. Only negative so far....I don't like that they have to be stored when not in use, but it's just a minor inconvenience. It...
  16. Tin Man

    SCREWED

    Sonny, sorry to hear of your situation. I am glad no one was physically hurt by the storm. As already mentioned, kudos to you for talking it in stride and getting to repairs ASAP. May you and your family Stay Safe!
  17. Tin Man

    Deciding between two boats, G3 185 VF and Alumacraft 185 Trophy

    I recently purchased a new '23 Tracker PG V16 SC. Heck, I thought $27K OTD was high! I understand depreciation very well. I plan to keep my boat for many, many years. It's NOT a financial investment; it's an investment in personal enjoyment, ease of use, reliability, and FUN! I saved and...
  18. Tin Man

    Too hot to fish

    SoCal temps in the high 90s-low 100s since June. These temps are almost everyday. It’s desert temps, so mostly dry heat, although we have had some high humidity in the last few weeks. Humidity is the worse! Go out at 7am and off lake by 12pm. Looking forward to Fall and cooler temps.
  19. Tin Man

    My 2022 SunTracker 22DLX Thread

    Your surroundings look amazing! That is as a chill as it gets! No wonder you purchased a 'toon!
  20. Tin Man

    How many of you enjoy a "Beater Boat?"

    I can relate to all boats....older, well used, show pieces, and beaters. I purchased my first new boat, a Pro Line 22 WAC back in 1998. Great boat and fished saltwater for several years. All other boats (except for my current new one) were 10-30 years old, but well maintained. Owned 10-15...
Top