Search results

Well, you might need the 14p after all. But wait until you can get the rpms first. If so, it would be cheaper to have the 13p you have repitched. Unless where you bought the prop will let you swap it. My dealer will allow one swap, with no money involved. As for the plug on wire. Not sure ...

Thanks guys Sent from my iPad using Tapatalk

oh really. Then maybe I won’t be using them I haven’t checked on how much they cost yet thanks Sent from my iPhone using Tapatalk

I can’t remember the name, something like Y2K. Anyway they are actually for venting livewells. But Iam going to put 2 in my bilge lid. To vent that compartment. Sent from my iPad using Tapatalk

ok guys thanks . One more question please. What does the boiling do to the linseed oil. Thanks Sent from my iPad using Tapatalk

awsome thanks Sent from my iPad using Tapatalk

What to seal new plywood decking, Spars carpet going on top. Thanks Sent from my iPad using Tapatalk

I would put it beside the cup holder on port side, of the back bench. Or in front of the driver on starboard side, on the middle seat. Sent from my iPad using Tapatalk

thanks Sent from my iPad using Tapatalk

wow that’s awesome. Come on tell all. What is this method. Sent from my iPad using Tapatalk

where did you get the new sticker Sent from my iPhone using Tapatalk

I will be using this, to replace my foam. It’s use by a lot of the boat racing community. And it can be sculpted to your needs in areas where drainage is a must. Then Iam spraying truck bed line from cans. On top so water won’t sit on it to eventually soak in and saturate. This was my problem...

Wow this is a cool build. Great job. Sent from my iPad using Tapatalk

Thanks fr the pics. Looks great Sent from my iPad using Tapatalk

Thanks I appreciate it. Sent from my iPad using Tapatalk

Like to see a pic of the bilge compartment. The layout pacifically. This is how I might end up on mine, with a 6gal tank. Sent from my iPad using Tapatalk

Well your on to something cool. I’ll be watching this build. Sent from my iPad using Tapatalk

Hey great job, curious how did you bend the flanges on the pieces you cut out did you use a break or what other method thanks. Sent from my iPad using Tapatalk

You have to stop the pump. The over flow tube won’t be able to keep up with the pump. And will over run. Rule of thumb is to fill as high as you can. So that when you launch out of the hole, and the bow rises. The water doesn’t slosh onto the deck. When the water needs to be refreshed. You just...

Hey Tim, You could make this deck so it’s removable. What if you rivet a C channel a long the front edge of the bench seat. And cut the plywood so tight. That you push it up under the fore deck, then pull it back in to the channel. Then screw though the channel into the wood decking. And put...