Search results

....We sure had a lot of fun. I put together a little highlight video of some of the fun we had in the Tracker. Now it is time to move on to the Weld-Craft.

I've been looking for an upgrade from my 92 Tracker Pro 17 (1750) and finally came across one I couldn't pass up. I picked up a nice 05 Weld-Craft 1852 Semi-V with a 115/80 Mercury. Tonight I pulled the 2 group 29 batteries and charger out and replaced then with my pair of 60ah lithiums. That...

Hey guys I am looking for another OB Jet boat. Mine was hit in an accident so I am looking for a replacement. What are some good places to search for used OB jet boats? I have been browsing Facebook market place for the most part but not finding many to choose from. Any suggestions? I would love...

I was on my way back from Grand lake heading east on I44 and must have seen at least 10-15 OBJ's! I am a loner here in OH with the OBJ.

I am going to replace the bearings in my jet pump and the impeller for the cooling system. Is there any tricks or any problems that I need to watch out for? I know to install the bearings I am going to need to have access to a press and I am trying to get that lined up still. I have a model L pump.

Does anyone know what my hull thickness is on my 92 Pro17 Tracker? Or do you know where I can find that info?

Well over the weekend I found out just how far I can run in 4" of water! For my ride 50yds is the limit. #-o Had to drag her back into floatable water then walk her downstream about 100yds to get to an area I could take off in again. I feel like I went from rookie to seasoned vet now. :lol...

I am sure this a liner has a lot more wear in it than you want but is there a way to clean it up a little? I was thinking a drill hone will do the job.....as long as I don't remove to much material. What do yall think? Good idea or bad idea?

Well I had the chance to finally get a little work done to my jet. I cleaned up the impeller(really need to order a new one) the leading edges were almost flat. I staightend the grates and put a small chamfer on the bottom side. Also I set the spacing of the impeller to the wear ring. It had a...

Hello noobie here and I have a question about a new to me 92 Tracker Pro17/ 60/40 Evinrude jet. What type of performance should I expect out of it? Right now the intake grate is bent up and it looks like the impeller's leading edge is rounded. Also the boat has 4" of setback with the riser...