Search results

when I came home for lunch I pulled the hose leaving the pump and it poured out almost brownish at first and then the blueish gas/oil color. I noticed it is leaking at the gasket a little. Later.. When I got home from work its been warm and the tank has been in the sun today still hooked up to...

Dang! at this point i was really hoping that was it... still died out without constantly priming. Hopefully the gasket solves the problem but I feel my shortcut of being cheap might have bit me in the @$$

If thats a stupid question...here's mine... Where would that be on my 6gal Attwood tank?

https://youtu.be/fcg27KQWYeU here's a video of what's going on

Just ordered a new gasket for between the pump and manifold. I've replaced every part of the fuel line so if that doesn't fix it I'm going to assume I bought a bad fuel pump and replace that again. It was a used part I bought off ebay. Once again, I tried being cheap and I end up paying twice as...

@pappy will it go completely soft ?

I'm trying to track the possible leak.. I started from the carb to the pump then got a new primer, replaced the hose from primer and attached it straight to the fuel pump. I'm going to bypass the quick connect to the gas tank tomorrow and see if that's where it's catching air. It's one of those...

Awesome! I've been at a stand still trying to get this motor fixed. I still haven't even sent my paperwork in for my registration. I've made a lot of progress with the motor though. Once I get it really going and get the registration I'll start to slowly restoring the boat. Have you started a...

I got my motor running for the first time since I bought it. I had problems with the starter assembly and i broke down and toon it to a mechanic. They told me the fuel pump needed to be replace so i ordered the part and I replaced it. I got it running but it still starts to die out until I pump...

They just don't understand! lol I still have to get my title. I got lucky getting around no title... I'm stationed in Louisiana and you can't do ANYTHING without a title here and I thought I was at a loss. Luckily I'm a legal resident of Michigan and they don't require a title or even a...

Awesome job so far!

While I'm trying to decide what to do with the interior and weather was nice this weekend... I decided to sand the exterior and prime it for paint. I was able to just use a wire wheel on my 4 1/2 in angle grider to get all the old paint off. Debated on buying some aircraft paint remover but I...

Bstanz I'm having a hard time pulling the trigger on ripping that seat out, not sure if I'm ready to get in over my head. I tend to have bad luck!

Any Updates?

Nice looking boat already! What's your first plans?

Alright... Starter cable broke on me last week so i tried to replace it, acording to the manual I needed to take a screw driver and turn the screw on the top 18 turns counter-clockwise. I did and it and just replaced the pull cord. After I got the pull cord on it I pulled it 1 time and it...

Does anybody have a good idea for a fabricated rib? If I remove a bench seat how could I replace the support it creates?

Ahhhh! That makes sense! Thanks Warefishin I'll look into steelflex

I really appreciate all the good advice! Did a lot of head scratching today... I went and picked the boat up yesterday evening and brought it home. When I saw it for the first time I knew it wasn't 48'' wide on the floor but honestly I was too excited and thought I was getting such a good deal I...