Search results

Need some input...I'm looking at buying a new outboard. Thinking about Nissan or Tohatus. How are these motors ? Are they the same motor, just different names. The Tohatus is about $30.00 cheaper. Thanks for your help....

My wife is getting tired of me comming home with acid holes in my clothes. What is the best Maintenace free deep cycle battery for trolling ?

I'm planning on decking my 14ft V-hull and need some advise. I was thinking about using 2x2's and 11/32 plywood. I'm not going to deck it like a bass boat, just on the bottom for a level place to stand.

I have a 14ft V-Hull and would like to install a floor. Don't won't to deck it out like a bass boat, just a plywood floor. Been looking around the site and there is alot of info about doing this for jon boats but not V-Hulls. Need some help. Thanks..

The Battery didn't have AMP hours on it....Thanks for your reply.

I purchased a Energizer Deep Cycle Size 29 Battery. MCA 875, RCM 210 and CCA 675. Does anyone know the AMP Hours for this Battery.

I fish alot of the reservoirs which allow electric motors only. Looking for a good battery which will give me lots of run time. I have a 14ft V-Hull with a 55lb thrust motor.

Great idea ...

Old Bill....Sounds good to me....I"m gonna give it a try.. Thanks again for all your help...

Old Bill...The Alumium is so thin on the bench I was worried if I mounted the seat to it, after time those screws would work their self loose. On yours did you use 1/2" plywood and screw the plywodd to the bench. Thanks.....

Thanks...Just making sure.

Place the 1/4" aluminum on the bench and drill a holes thru the 1/4" aluminum and the bench. Is this correct ? Thanks again.

I have a 14' aluminum V-Hull with the tank type bench. Would like to mount seats. I've tried the clamp on type, but when you lean back or side ways they pop off. I do not want to drill holes in the bench to mount them because the aluminum doesn't feel that thick and I can't get under the bench...