Search results

This battery weighs 100lbs and runs my minnkota 12v 55lb thrust trolling motor. Anyone out there know what type it is. It’s a beast, but weighs too much

How did you cut the ladder

Interesting. A gentleman in the neighborhood said that if the board had been a 2x10 or 2x12 it would be pretty solid but the fact that only one bolt holding the current board,the transom is weaker.

Thank you all for the responses. It looks like a full transom fit of plywood to fit the width of the cap is the direction. Appreciate it.

I’m adding these new photos. My plan is to replace the three 2x that are running horizontal. If I replaced those with plywood in a single cut, would I get a stronger transom?

Thank you for this response. I have the plywood on hand and will bondo epoxy resin after joining the two pieces together. My biggest concern is the bottom of the two transom braces. They are attached by rivets to the floor. Any ideas to fix after removing the braces or will I be lucky...

15hp At WOT the top 2x4 (which has just one bolt trough it in a weak spot) flexes.

It doesn’t do that but it appears that instead of single cut plywood, it was done with 2x4s.

Thanks. How much flex should be on the transom. It appears that there is a piece of 1/8 plywood missing from the transom

Yes it is still solidly mounted to the floor. Yes bolts look rough and rusty. It is not cracked.

Any recommendations on how to repair this transom brace? Best options