Search results

Does anyone have a "How To" replacing a pull rope on a 74' Evinrude 9.9 ? I assume it's similar to doing it on a push mower ...

I called a few shops and coworkers agreed time for prop . thank you for your reply

Last time on the water I was going full throttle across the Lake to the ramp and the boat slowed down suddenly.The motor was still revved up high RPM but the prop would only spin at low speed . When I lowered the throttle it worked fine to get me back to the ramp ?

I just added a SliderG5 seat mount to alleviate the problem of the tiller handle hitting the seat.

I did my front deck with Tuff Coat (light gray) from BPS. I wirebrushed the diamond plate with a SS cup brush in my cordless drill . Then the instructions told me to wipe the surface down with laquer thinner and paint with selfetching primer. I wanted to see how it held up before doing the...

I just installed my light gray SliderG5 and it alleviated the problem I had with my tiller handle hitting my seat. The seat slides across the mount so smoothly can't wait to try it on the water , customer service is #1 which is hard to find these days.

I got the cheapest one I could find, mainly for depth monitoring. I've seen fish all over the finder and they wouldn't bite.It don't put them in the boat but atleast you know your not fishing in the wrong spot.

I made these with 1.5" channel aluminum and Driftmaster rod holders, trying them out this afternoon.

I fabricated these night fishing lights with LED racing lights from Advance Auto,1.5" channel aluminum,clamps and 12volt cords from harbor freight, and covered it with the largest heat shrink I could find. The lights are very bright and even hooked them to a battery for 5 days ,they never got...

Light Gray is the color that would match my boat best , is there a number to call ? I'm more concerned if the slider would fix my problem, the tiller handle on my '74 9.9 Evinrude hits the seat when centered . What is your return policy if the SliderG5 doesn't work with my seat/boat combination...

I ran into a snag recently when I went to mount my rear seat with a clamp-on mount,the tiller handle on my 74' Evinrude hits the seat when it is centered on the original bench seat. I really can't move my front seat for balancing either . I purchased an Atwood slide mount, but I'm not sure if it...

I would like to see pics of your boat, does the Rustoleum bedliner come in colors or just black ? I looked at several projects before I took the foam out,some boats have no foam.It's just for flotation so it doesn't sink . I still have foam in the rear seat and the original bow seat under the...

I always plan to go around the next full moon and I have a fishing Barometer which helps, but I have also found it to not matter if the fish are hungry they bite but just like a fish finder doesn't make them jump in the boat. I go when I can just like to be outside . The more you go the more...

Thank you

After I wire brushed the diamond plate and wiped it down with acetone, I sprayed it with self-etching primer and applied light gray Tuff Coat from BPS to the trolling motor deck. I added a co-pilot , the remote control is too cool !

Update : I used Shoe goo to glue the conduit on the side of boat and then finished it off with some clear RTV after it dried . Just need some rod holders and mount the anchor mate and some fish ...

:)

*Updates* Yes that is a Genie garage door handle ...

Great work ! just curious where you got the hatch hitches and what kind are they ?

My plan is to apply light gray Tuff Coat on the diamond plate .