Search results

Mod-V is my preference. It tracks a little straighter than a flat bottom Jon and handles chop ok, but not as good as a deep-v. As far as brands go I have a Starcraft but I think any all-welded boat should be fine. Look for something that is all aluminum including the floor. The new Lowe Stinger...

did you check with the OB charger manufacturer to see if they have any diagrams that match what you're trying to do? I would give them a call and ask for some assistance.

not sure what you are looking to do. pictures and more details would help us provide some guidance.

I did some research on water-proof digital cameras a while back for my Dad's b-day. I found that the Olympus Tough cameras seemed to be very good but the zoom was only 5x. I prefer Panasonic (also make a very nice WP digi camera) but again the zoom was low at 4.6. Haven't seen any at 10x yet.

the lower unit and skeg are normally one piece. Is yours different, a bolt-on?

how's this list? compressor and hoses pneumatic rivet gun chop saw band saw jig saw hole saw kit drill drill press sheet metal brake angle grinder with assorted disks and flap wheels sander bench vise welder with spool gun (if budget allows) safety gear

Welcome!

If you have the time and budget then I think this boat could be a good start. I like that it appears to be complete and not missing anything major. Does everything work? How's the trailer? The last thing I would want is someone's "project" that looked more like a hull full of loose parts. Good...

Thanks Bob. Couple of questions for you... the battery hatch is vented on the underside near the motor. the opening is about 2" high x 40" wide. Is that sufficient? Also the gas tank is in the front under the deck and wasn't vented from the factory. Should I install a vent here? Dave

This boat mod hobby is addicting which naturally leads me to thinking about doing more. I know some of you guys finish a build then move on to another so I'm assuming you have permanent shops. How are your shops setup? And what tools are required? I'm specifically interested in shops setup for...

Yes you can build with aluminum (use 6061). Check out Bassboy's builds. He pretty much wrote the book on building with aluminum. Makes nice trolling pedal trays too I suggest getting one from him if needed. (American Made!) Yes a 3 bench boat can be converted but keep in mind that the seats can...

question about glue for you guys: the floor is currently vinyl, I tried a test patch using Henry's outdoor glue but it peeled right off. can I glue carpet over it? If so what kind of glue do I need? thx

WOW! is there any damage to the gunwale or keel in that general area? The reason I ask is it sounds like the hull might be flexing too much in that area. I would take it to a metal fab shop and see it they could replace to entire piece. best of luck

I love my Leatherman Charge I just wish they would come out with one that has longer jaws for fisherman. Anyone have the Gerber Flik Fish? How is it?

what type of stapler did you use? Pneumatic or manual?

if you are going to add some framing support under the deck I don't see any problems with strength or durability. Did you check your local boating regulations to see if there are any restrictions on not having a grab rail or gunwale?

that's a good start. My advice ...be methodical in your approach so as to not produce redundant tests and get your hands on the repair manual. Make a plan and focus on one circuit at a time. Start with the kill switch, ignition, starter and so on. Good luck beerman

I have a Starcraft 1860 (18' 6") with a 75. It will run at 35-40 mph with a full load. I think both of your choices are paired well. What types of fishing will it be used for? beerman

interesting idea...my concern would be losing things overboard

getting close to completion. here are some new picts...