TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
15 HP Evinrude help - No power or rpms
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="wmk0002" data-source="post: 417998" data-attributes="member: 13975"><p>Thanks for the info and reassurance guys. I will definitely do the full conversion later on, not just the carb.</p><p></p><p>As of now, I'm moving back to trying to get the 15hp going. At least if I get that running right I can run it on my hull and know for sure how a 15hp should really perform on it.</p><p></p><p>Speaking of the 15hp, yesterday I tried to remove the flywheel to check everything out under there but was left hanging as my puller kit didn't have bolts that would fit in the smaller holes. So I visually checked out the exhaust passage on the leg and it looked good. Then rechecked cold compression and got about 108 psi on each cylinder. I still need to check the fuel pump condition but aside from that my next priority is going to get some grade 8 bolts to pull the flywheel with.</p></blockquote><p></p>
[QUOTE="wmk0002, post: 417998, member: 13975"] Thanks for the info and reassurance guys. I will definitely do the full conversion later on, not just the carb. As of now, I'm moving back to trying to get the 15hp going. At least if I get that running right I can run it on my hull and know for sure how a 15hp should really perform on it. Speaking of the 15hp, yesterday I tried to remove the flywheel to check everything out under there but was left hanging as my puller kit didn't have bolts that would fit in the smaller holes. So I visually checked out the exhaust passage on the leg and it looked good. Then rechecked cold compression and got about 108 psi on each cylinder. I still need to check the fuel pump condition but aside from that my next priority is going to get some grade 8 bolts to pull the flywheel with. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Boats
Motors
15 HP Evinrude help - No power or rpms
Top