TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
15" transom JonBoat - what length shaft trolling motor?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="billz" data-source="post: 500375" data-attributes="member: 33787"><p>Thank you Axhammer. Those measurements and the rear picture against the outboard are exaclty what I needed to see. Good to know that a 30 inch shaft is 30" from the base of the control unit to the center of the prop.</p><p>Airshot, measure twice cut once. Then again, dont cut too short. Ha</p><p>Challenger, I didnt know if the 30" measurent was based on the lock collar, Axhammers pictures helped on that.</p><p></p><p>Thank you for all the responses.</p></blockquote><p></p>
[QUOTE="billz, post: 500375, member: 33787"] Thank you Axhammer. Those measurements and the rear picture against the outboard are exaclty what I needed to see. Good to know that a 30 inch shaft is 30" from the base of the control unit to the center of the prop. Airshot, measure twice cut once. Then again, dont cut too short. Ha Challenger, I didnt know if the 30" measurent was based on the lock collar, Axhammers pictures helped on that. Thank you for all the responses. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
15" transom JonBoat - what length shaft trolling motor?
Top