TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
1956 Evinrude Lark 30 HP Tear down
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Shaugh" data-source="post: 476126" data-attributes="member: 19781"><p>just put a nut on and grind it down to fit the smaller hole. no don't take the pinion out.... needle bearings... The drive shaft will pull right out though. you'll need to replace the seal in the top of the water pump cover too. The screw method he shows works for prop, pump and upper seals. I usually grind the tip down on the screw a little so it scratches less...</p><p></p><p>https://www.youtube.com/watch?v=H52J-XPTx24</p></blockquote><p></p>
[QUOTE="Shaugh, post: 476126, member: 19781"] just put a nut on and grind it down to fit the smaller hole. no don't take the pinion out.... needle bearings... The drive shaft will pull right out though. you'll need to replace the seal in the top of the water pump cover too. The screw method he shows works for prop, pump and upper seals. I usually grind the tip down on the screw a little so it scratches less... https://www.youtube.com/watch?v=H52J-XPTx24 [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Boats
Motors
1956 Evinrude Lark 30 HP Tear down
Top
