TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
1980 J25RCSA coil assy
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Riverbean" data-source="post: 480615" data-attributes="member: 26108"><p>Did some reading and i will be sealing it with the 518 wich its intended use is for...271 is a permanent thread locker.. Both are anaerobic, id think either one would have worked but the 271 did not...also my service manual says to apply sealant to both flanges where i only applied the 271 to one.. Gonna seal. And torque it back down and re torque everything and get ready to prime it...acetone good for getting any oil,dirt,grease etc... Off before priming? Or is there something better?</p></blockquote><p></p>
[QUOTE="Riverbean, post: 480615, member: 26108"] Did some reading and i will be sealing it with the 518 wich its intended use is for...271 is a permanent thread locker.. Both are anaerobic, id think either one would have worked but the 271 did not...also my service manual says to apply sealant to both flanges where i only applied the 271 to one.. Gonna seal. And torque it back down and re torque everything and get ready to prime it...acetone good for getting any oil,dirt,grease etc... Off before priming? Or is there something better? [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
1980 J25RCSA coil assy
Top