Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="tomme boy" data-source="post: 436752" data-attributes="member: 11342">That new carb should make a big difference. Did you get the upgraded primer when you rebuilt the carb? You are lucky that you have the WMC carb and not the BC style. Mine was acting funny today. I think I am going to have to replace the inlet needle. Or adjust the float. It wanted to flood out a little bit. It would spit out gas from the front of the carb and then would take off and run fine. Last time it did this the little rubber tip on that needle was not sealing and gas would spray out the front of the carb. Going to get one tomorrow just to be safe.</blockquote>