TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
1985 Alumacraft Bandit rebuild and gigging boat conversion.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="CaptainPJ" data-source="post: 463509" data-attributes="member: 24394"><p>Sand blasted the inside, cleaned metal, alodined metal and epoxy bogged the corroded areas. Laminated three sheets of Aquaplas II and cut to fit transom. I installed the transom this weekend. Next up is installing one of the ribs I pulled out for repair then paint the inside of the hull. </p><p>I'm using Total Boat Aluminum barrier coat for a epoxy primer. I'll spray 4 thin coats then spray a couple coats of Epoxy top coat(Aircraft paint my buddy gave me). </p><p>Once the inner hull is painted I will start making and installing bulkheads which I will paint prior to install. </p><p>After the bulkheads I can figure out how to run conduits for hoses wires and cables. I will also work out battery placement and how to mount a center console. The boat had a side console which is going on the scrap pile. I like to stand up while I drive.</p></blockquote><p></p>
[QUOTE="CaptainPJ, post: 463509, member: 24394"] Sand blasted the inside, cleaned metal, alodined metal and epoxy bogged the corroded areas. Laminated three sheets of Aquaplas II and cut to fit transom. I installed the transom this weekend. Next up is installing one of the ribs I pulled out for repair then paint the inside of the hull. I'm using Total Boat Aluminum barrier coat for a epoxy primer. I'll spray 4 thin coats then spray a couple coats of Epoxy top coat(Aircraft paint my buddy gave me). Once the inner hull is painted I will start making and installing bulkheads which I will paint prior to install. After the bulkheads I can figure out how to run conduits for hoses wires and cables. I will also work out battery placement and how to mount a center console. The boat had a side console which is going on the scrap pile. I like to stand up while I drive. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
1985 Alumacraft Bandit rebuild and gigging boat conversion.
Top
