TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
1989 17' tracker pro 17 mod
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="dearl" data-source="post: 105921" data-attributes="member: 1760"><p>Thanks Russ and deerslayer for the tips, I was thinking about adding some bracing from the floor supports up, to kinda tie the sides into the floor to stop this from happening again. Well I did it! I finally finished sanding all that nasty black paint and epoxy off this boat, all I have to do now is go around all the rivets with a small torch and a wire brush to remove any left over epoxy and paint, and then I can start welding. I am going to look into the brazing rods that rat spoke about, looks like some good stuff. I probably wont get anything done till after labor day, got a lot of things to do at work this weekend.</p><p>[ATTACH=full]8426[/ATTACH]</p><p>[ATTACH=full]8427[/ATTACH]</p><p>[ATTACH=full]8428[/ATTACH]</p></blockquote><p></p>
[QUOTE="dearl, post: 105921, member: 1760"] Thanks Russ and deerslayer for the tips, I was thinking about adding some bracing from the floor supports up, to kinda tie the sides into the floor to stop this from happening again. Well I did it! I finally finished sanding all that nasty black paint and epoxy off this boat, all I have to do now is go around all the rivets with a small torch and a wire brush to remove any left over epoxy and paint, and then I can start welding. I am going to look into the brazing rods that rat spoke about, looks like some good stuff. I probably wont get anything done till after labor day, got a lot of things to do at work this weekend. [ATTACH type="full" alt="DSC00012.JPG"]8426._xfImport[/ATTACH] [ATTACH type="full" alt="DSC00013.JPG"]8427._xfImport[/ATTACH] [ATTACH type="full" alt="DSC00014.JPG"]8428._xfImport[/ATTACH] [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
1989 17' tracker pro 17 mod
Top