TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
2002 Lowe 1467t Mods
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Johny25" data-source="post: 340045" data-attributes="member: 7791"><p>I believe I used 1/2 inch but I have good stringer support underneath. I wish I had taken pics of the framing before I covered and finished it as it is going to be hard to explain what I did. Basically I mounted a ledger board on the front side of the front bench that the 1/2 ply rested on and was flush with the top of the bench seat (I couldn't go over the bench with just one piece of plywood). Then I made a bracket that mounted to the front U bolt that the boat is pulled onto the trailer with. I also put in up rights underneath as support. It took me some time to figure it all out and without being able to show pics it would be impossible to explain. If my boat wasn't in storage I would try and put the camera underneath inside the battery box and snap some pics for you. When I go get it in the spring I will take pics if you want</p></blockquote><p></p>
[QUOTE="Johny25, post: 340045, member: 7791"] I believe I used 1/2 inch but I have good stringer support underneath. I wish I had taken pics of the framing before I covered and finished it as it is going to be hard to explain what I did. Basically I mounted a ledger board on the front side of the front bench that the 1/2 ply rested on and was flush with the top of the bench seat (I couldn't go over the bench with just one piece of plywood). Then I made a bracket that mounted to the front U bolt that the boat is pulled onto the trailer with. I also put in up rights underneath as support. It took me some time to figure it all out and without being able to show pics it would be impossible to explain. If my boat wasn't in storage I would try and put the camera underneath inside the battery box and snap some pics for you. When I go get it in the spring I will take pics if you want [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
2002 Lowe 1467t Mods
Top