Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="Redwood Charlie" data-source="post: 522984" data-attributes="member: 37119">I sure hope someone can help me because I'm out of ideas. No water was coming out of the "p-hole" The motor temp never got over 145 according to the Sea View app but there was no water coming out of said hole. I pulled the lower unit and replaced the impeller. The impeller was tired but not defective in any way. I decided before just bolting it back on I would try to flush the system with a hose first. I removed the thermostat because I was going to replace it too. 1st I flushed from the bottom and water came out of the thermostat hole no problem. Then I flushed thru the thermostat and water came out the bottom pipe no problem.Then I plugged the bottom intake and tried flushing thru the thermostat to see if I could get water to flow from the P-hole and nothing. The last thing I did was screw the hose into the P-hole to back flush and no water came out of the thermostat or the bottom intake pipe.I did not crank the water wide open but it did have decent pressure. I did push a wire into the P-hole as far as I could but it stopped after about 6 inches. Any and all ideas are welcome</blockquote>