TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
2010 Evinrude Etec 115 Jet Pump Motor Revs but wont go. Help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="1986Landau" data-source="post: 441111" data-attributes="member: 15457"><p>Hey guys,</p><p></p><p></p><p>My buddy has a 2010 Evinrude Etec 115 with a jet pump on a 19 foot Lowe, it usually goes about 30-40 mph but the last time it was in the water when we were in Houston it wouldn't open up and it would only do about 10 mph. it seamed like it was okay to a certain rpm and then if you kept easing up on the throttle the engine would rev up but it didn't seam to go any faster. We didn't need to go any faster in the situation we were in but want to get this addressed before hitting the water again. We are not familiar with these jet drives and there are no local marinas in our area. Do any of you have any tips, ideas on what we should look at first? Anything that would cause the power to be lost between the crankshaft and the jet impeller like something that would be slipping?</p></blockquote><p></p>
[QUOTE="1986Landau, post: 441111, member: 15457"] Hey guys, My buddy has a 2010 Evinrude Etec 115 with a jet pump on a 19 foot Lowe, it usually goes about 30-40 mph but the last time it was in the water when we were in Houston it wouldn't open up and it would only do about 10 mph. it seamed like it was okay to a certain rpm and then if you kept easing up on the throttle the engine would rev up but it didn't seam to go any faster. We didn't need to go any faster in the situation we were in but want to get this addressed before hitting the water again. We are not familiar with these jet drives and there are no local marinas in our area. Do any of you have any tips, ideas on what we should look at first? Anything that would cause the power to be lost between the crankshaft and the jet impeller like something that would be slipping? [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
2010 Evinrude Etec 115 Jet Pump Motor Revs but wont go. Help
Top