Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="Pale_Horse_Idaho" data-source="post: 513037" data-attributes="member: 35352">I measured to old trim cap with a cloth tape measure holding to the surface for the whole measurement. I then had the shop make it 3 inches longer. I will trim off excess when done. It should be ok. Its not centered in the picture. I just set it up there for the photo.Do they make an adjustable drill guide that would allow me to set the angle of my transom and drill. I know about corner pocket jigs but they are fixed. Handy little tools.Measure to the top of the hole on the inside and knee brace 1.269 and from the top of the hole on the outside 1.329. So its not much of an angle but its there.</blockquote>