TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
21ft flat bottom The "Bucket"
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Flat Bottom" data-source="post: 267402" data-attributes="member: 4594"><p>Alright tinboaters... floor is about as done as it's gonna be. I have not put any side material on yet, waiting on the initial test run to make sure everything is legit. Today I got the console fastened down good, got the engine controller attached nicely and got the piece i'm going to place over the old console face cut and coated with urethane (1st coat) Got the old console face cut out so I'll have room to put the steering wheel and either a switch board or some independent switches. Foamed in some spots on the bottom of the sides next to the floor. Tomorrow the plan is to get the last coat or two on the new console face, and get the steering wheel installed to i can take the boat on a test run. The weather around here has been extremely Sh@#$%^ lately so it's hard to get stuff done, and i may be doing a test run in 3" swells... (that's how i seem to test everything out for some reason...) Here are a couple pictures of the progress and with any luck tomorrow i'll be out on the water.</p></blockquote><p></p>
[QUOTE="Flat Bottom, post: 267402, member: 4594"] Alright tinboaters... floor is about as done as it's gonna be. I have not put any side material on yet, waiting on the initial test run to make sure everything is legit. Today I got the console fastened down good, got the engine controller attached nicely and got the piece i'm going to place over the old console face cut and coated with urethane (1st coat) Got the old console face cut out so I'll have room to put the steering wheel and either a switch board or some independent switches. Foamed in some spots on the bottom of the sides next to the floor. Tomorrow the plan is to get the last coat or two on the new console face, and get the steering wheel installed to i can take the boat on a test run. The weather around here has been extremely Sh@#$%^ lately so it's hard to get stuff done, and i may be doing a test run in 3" swells... (that's how i seem to test everything out for some reason...) Here are a couple pictures of the progress and with any luck tomorrow i'll be out on the water. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
21ft flat bottom The "Bucket"
Top