TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Electrical
About to start from scratch wiring my boat
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="wmk0002" data-source="post: 418799" data-attributes="member: 13975"><p>Thanks jethro. I'm still open to running the wiring under the floor. I really didn't want to do it on order to keep the strakes free for good water drainage but it probably won't really hinder that much.</p><p></p><p>When you ran yours under the floor and reached the front deck how did handle the wiring from that point forward to the TM? We may have totally different layout boats but since I am leaving my foam under my front deck intact, I think I would have to use some type of wire loom and run it up and then down the side to install the TM plug receptacle.</p><p></p><p>Regarding fishing wire through the rail/gunnels, I did buy a nice 160 piece rubber grommet set off of Amazon a few weeks back that should really clean up the holes in it if I decide to go that route.</p></blockquote><p></p>
[QUOTE="wmk0002, post: 418799, member: 13975"] Thanks jethro. I'm still open to running the wiring under the floor. I really didn't want to do it on order to keep the strakes free for good water drainage but it probably won't really hinder that much. When you ran yours under the floor and reached the front deck how did handle the wiring from that point forward to the TM? We may have totally different layout boats but since I am leaving my foam under my front deck intact, I think I would have to use some type of wire loom and run it up and then down the side to install the TM plug receptacle. Regarding fishing wire through the rail/gunnels, I did buy a nice 160 piece rubber grommet set off of Amazon a few weeks back that should really clean up the holes in it if I decide to go that route. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Boats
Electrical
About to start from scratch wiring my boat
Top