Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="PSG-1" data-source="post: 406187" data-attributes="member: 6937">Yeah, that was a dilemma when I first started putting the whole thing together, how to tie the bars together.On the backside of the pivot block, where those 2 pivoting center bars are located, I had to gouge out with my grinder, to give me enough room to access to the fit-up where the 1/4" stainless rod goes through the bars, so I could get in there and tack weld them with the TIG welder. That was a tight space, for sure, and I had to be real careful about how I did it, otherwise, I would have fused the bars to the pivot block.</blockquote>