TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Alumacraft V16 Modification
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="MrGiggles" data-source="post: 492660" data-attributes="member: 22613"><p>I guess I don't see the upside of cutting out the rear bench to put a seat there. If that's what you want to do, just put a pedestal base on top of the bench, that will allow the seat to be removed and swivel. If you want more room back there take it out altogether, and tie the sides into your subfloor. You want it to be strong, the rear portion of the hull has the most stress on it. I would have braces that run up to the gunnels, fastened to the hull, that tie into the transverse stringers which will support your floor.</p><p></p><p>A console of sorts on the side is common in tiller boats, although I've always seen it on the left side. Most have the gauges, switch panel, graphs, etc. mounted it to it.</p></blockquote><p></p>
[QUOTE="MrGiggles, post: 492660, member: 22613"] I guess I don't see the upside of cutting out the rear bench to put a seat there. If that's what you want to do, just put a pedestal base on top of the bench, that will allow the seat to be removed and swivel. If you want more room back there take it out altogether, and tie the sides into your subfloor. You want it to be strong, the rear portion of the hull has the most stress on it. I would have braces that run up to the gunnels, fastened to the hull, that tie into the transverse stringers which will support your floor. A console of sorts on the side is common in tiller boats, although I've always seen it on the left side. Most have the gauges, switch panel, graphs, etc. mounted it to it. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Alumacraft V16 Modification
Top