TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
Jet Boat Projects
CUSTOM JET JON FROM THE GROUND UP
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="silverbullet2003" data-source="post: 413484" data-attributes="member: 15202"><p>Got my floor pieces cut and temporarily layed in boat along with my walls over the weekend to make sure they fit. Had a delay in getting my foam sprayed in due to weather but got that done yesterday. Not as evenly sprayed as I would have hoped but the price was right and I'll never see it again so can't complain.</p><p>I called all over the country and I come to the conclusion that pillow bearings for my drive sprockets is out of the question. None Will handle the RPMs that I will be pushing, so back to the drawing board on that.</p><p></p><p> [ATTACH=full]1[/ATTACH][ATTACH=full]2[/ATTACH][ATTACH=full]3[/ATTACH][ATTACH=full]4[/ATTACH]</p><p></p><p>Sent from my VS990 using Tapatalk</p></blockquote><p></p>
[QUOTE="silverbullet2003, post: 413484, member: 15202"] Got my floor pieces cut and temporarily layed in boat along with my walls over the weekend to make sure they fit. Had a delay in getting my foam sprayed in due to weather but got that done yesterday. Not as evenly sprayed as I would have hoped but the price was right and I'll never see it again so can't complain. I called all over the country and I come to the conclusion that pillow bearings for my drive sprockets is out of the question. None Will handle the RPMs that I will be pushing, so back to the drawing board on that. [ATTACH type="full" alt="0515161232.jpg"]0[/ATTACH][ATTACH type="full" alt="0515161232a.jpg"]1[/ATTACH][ATTACH type="full" alt="0517161619.jpg"]2[/ATTACH][ATTACH type="full" alt="0517161619a.jpg"]3[/ATTACH][ATTACH type="full" alt="0518162049.jpg"]4[/ATTACH] Sent from my VS990 using Tapatalk [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Jet Boats
Jet Boat Projects
CUSTOM JET JON FROM THE GROUND UP
Top
