TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
DIY Gauge Panels and mounting plates???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="soky72" data-source="post: 481207" data-attributes="member: 6526"><p>I just picked up a 1999 SeaArk 1652, it's all welded and built like tank. The only problem is like most old boats it's full of cut outs and screw holes. Rather than getting everything patched on the console I figured id neatly cut out large areas and replace it with panels made with whatever, carbon fiber sheet? ABS plastic? Same for the electronics areas which I've seen someone use a cutting board as a mounting plate. Just looking for examples and suggestions.</p></blockquote><p></p>
[QUOTE="soky72, post: 481207, member: 6526"] I just picked up a 1999 SeaArk 1652, it's all welded and built like tank. The only problem is like most old boats it's full of cut outs and screw holes. Rather than getting everything patched on the console I figured id neatly cut out large areas and replace it with panels made with whatever, carbon fiber sheet? ABS plastic? Same for the electronics areas which I've seen someone use a cutting board as a mounting plate. Just looking for examples and suggestions. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
DIY Gauge Panels and mounting plates???
Top