Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="ChuckB" data-source="post: 519688" data-attributes="member: 34818">[ATTACH=full]122682[/ATTACH]Here is the straight edge. The main reason I want to raise it is to be able to get the bottom bolt in the wood part of the transom.At the very top of the bottom elongated hole it would be very close right now.  My plate is 1 3/4 inch below the bottom of the boat so maybe raise it one hole on the top. The engine manual says from 0.2 - 1 inch below the bottom of the boat. That would put it 1 inch and should provide enough clearance from the bottom of the wood reinforcement.</blockquote>