TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Evinrude Big Twin: runs on choke only
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Newtosa" data-source="post: 469999" data-attributes="member: 23589"><p>Hi everyone - an update.</p><p>. The idle mix needle washers are all fully compressed. </p><p>. Idle mix needle out 1 turn to 4-1/2 turns (1/4 turn at a time, run on choke for 15 to 20 seconds before trying to open the choke) didn't do the trick.</p><p>. Tomorrow I'll remove the starter, remove the carb, confirm the nozzle gasket at the bottom of the bowl is compressed to create the right vacuum. Will also confirm that high speed orifice is clear.</p><p>. If all that looks right, will re rebuild the carb (r&r plugs, float valve needle/seat, every hole and passage, make sure idle mix needle is fully seating, etc.) as soon as the kit arrives. Hopefully tomorrow.</p><p></p><p>I really appreciate everyone's help with this. Will keep you posted.</p></blockquote><p></p>
[QUOTE="Newtosa, post: 469999, member: 23589"] Hi everyone - an update. . The idle mix needle washers are all fully compressed. . Idle mix needle out 1 turn to 4-1/2 turns (1/4 turn at a time, run on choke for 15 to 20 seconds before trying to open the choke) didn't do the trick. . Tomorrow I'll remove the starter, remove the carb, confirm the nozzle gasket at the bottom of the bowl is compressed to create the right vacuum. Will also confirm that high speed orifice is clear. . If all that looks right, will re rebuild the carb (r&r plugs, float valve needle/seat, every hole and passage, make sure idle mix needle is fully seating, etc.) as soon as the kit arrives. Hopefully tomorrow. I really appreciate everyone's help with this. Will keep you posted. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Boats
Motors
Evinrude Big Twin: runs on choke only
Top
