TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Help with 1984 Mercury 25XD
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="BobW89" data-source="post: 310102" data-attributes="member: 11386"><p>You were right on the money. I went through all of the ignition measurements and found all meter measurements (ohms) were in tolerance. I then went back to the wiring diagram and checked every wire and found the faulty switch. </p><p></p><p>I was able to get her started and now moving on to timing. Thank you for the assistance. For those that may have the same motor, I posted the ignition measurements below. </p><p></p><p>Ignition Test Readings</p><p>Stator Leads - Blk/Yel & Blk/Wht 3.1 to. 3.7, Reading 3.11k</p><p>Trigger Leads - 6.5 to 8.5, Reading 7.86</p><p>Coil Leads - Primary (+) to (-) zero 0.0, Reading 0.001</p><p>Coils Leads - Secondary (Between Coil tower & (+) &/or (-)) 8.5 to 12, Reading 8.77</p><p></p><p>Again, thanks for the pointer. </p><p></p><p>Bob</p></blockquote><p></p>
[QUOTE="BobW89, post: 310102, member: 11386"] You were right on the money. I went through all of the ignition measurements and found all meter measurements (ohms) were in tolerance. I then went back to the wiring diagram and checked every wire and found the faulty switch. I was able to get her started and now moving on to timing. Thank you for the assistance. For those that may have the same motor, I posted the ignition measurements below. Ignition Test Readings Stator Leads - Blk/Yel & Blk/Wht 3.1 to. 3.7, Reading 3.11k Trigger Leads - 6.5 to 8.5, Reading 7.86 Coil Leads - Primary (+) to (-) zero 0.0, Reading 0.001 Coils Leads - Secondary (Between Coil tower & (+) &/or (-)) 8.5 to 12, Reading 8.77 Again, thanks for the pointer. Bob [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Boats
Motors
Help with 1984 Mercury 25XD
Top
