Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="lckstckn2smknbrls" data-source="post: 523625" data-attributes="member: 36805">I have a very similar trailer it's a 1970 Yarbrough. I'm doing the bunk on frame I will see if the skeg of my motor has enough clearance. If you haven't yet you need remove the tongue and inspect the pivot bolt hole for elongation. The hole in my old tougue was out of round by more than 1/4". The 8' long 3x3 had many holes drilled in it and had a kink in it, I have replaced it with a 10' 3x3. I did away with the tilt by drilling 1/2" in the flat under the roller mount by the tilt latch. Also check the wear where the tilt catches.</blockquote>