TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Electrical
How did you mount your fishfinder?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="onthewater102" data-source="post: 360102" data-attributes="member: 13702"><p>I'll get you a pic of how I mounted mine - I used (2) RAM mount 1" balls with a 1/4 20 threaded female at opposite ends of a piece of 1/2" PVC conduit with a threaded rod down the middle holding them together. I got the ram mount for the fishfinder I was using along with an extra compression fitting so I can pivot the display 2' forward of the middle bench seat, 2' to the side if I'm fishing off the port side, or 2' straight back toward the rear bench to see it better while on the tiller. </p><p></p><p>I've got side-imaging using the thru-hull transducer. Made me very nervous drilling a 1.125" hole straight thru the bottom of my boat, but after a ridiculous amount of marine epoxy I've got it to the point where it doesn't worry me anymore.</p></blockquote><p></p>
[QUOTE="onthewater102, post: 360102, member: 13702"] I'll get you a pic of how I mounted mine - I used (2) RAM mount 1" balls with a 1/4 20 threaded female at opposite ends of a piece of 1/2" PVC conduit with a threaded rod down the middle holding them together. I got the ram mount for the fishfinder I was using along with an extra compression fitting so I can pivot the display 2' forward of the middle bench seat, 2' to the side if I'm fishing off the port side, or 2' straight back toward the rear bench to see it better while on the tiller. I've got side-imaging using the thru-hull transducer. Made me very nervous drilling a 1.125" hole straight thru the bottom of my boat, but after a ridiculous amount of marine epoxy I've got it to the point where it doesn't worry me anymore. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Boats
Electrical
How did you mount your fishfinder?
Top
