TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Introduction and first mod
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="JAS114" data-source="post: 103850" data-attributes="member: 1987"><p>I forgot, I drilled 4 holes in the gunwale at the bow to mount the plate for the trolling motor with stainless screws and washers. There was already a hole in the very front of the bow that I ran a ss bolt and washer through. Other than that, the only other holes I plan on are 4 screws to mount the 5/5/5 charger to the back of the rear bench and 2 in the transom (transducer wire and bilge pump through-hull).</p></blockquote><p></p>
[QUOTE="JAS114, post: 103850, member: 1987"] I forgot, I drilled 4 holes in the gunwale at the bow to mount the plate for the trolling motor with stainless screws and washers. There was already a hole in the very front of the bow that I ran a ss bolt and washer through. Other than that, the only other holes I plan on are 4 screws to mount the 5/5/5 charger to the back of the rear bench and 2 in the transom (transducer wire and bilge pump through-hull). [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Introduction and first mod
Top